Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I canfigured localized policy for QoS per VPN, but i can not find where to apply localized policy if i used configured group.
Does anybody have some experiance with it. I have 3 VPN, VPN10, VPN11, VPN12. I use 2 ISP. i want to make that VPN ...
Hello ,
We would like to implement SD-WAN UTD security on a Cisco C8200 router at our branch location. Our goal is to enable Direct Internet Access (DIA) with security features.
I would like to know if it is possible to perform SSL inspection for al...
Hello,
I have installed cisco ISE PIC 3.4 and integrate with FMC to do passive authetication, I can see users and users works correctly in some time that users lose conection and I can see that user is made Log off in FMC-User activity, but users...
Hello,
i have installed Cisco ISE PIC 3.4 version and use RPC agent as connection with AD. Made integration with FMC and create rule to filter URL per user. I have noticed that FMC don't get information when user log off and FMC alone in some time m...
Hello,
I have installed cisco FPR 1150 managed by FMC. i enabled allow ICMP protocol through Platform Policy, i can not ping my outside interface from outside network. Does anybody have same problem.
Version is 7.2.4
Thnaks.
Hello,Thank you for your answer.I configured an 80 MHz channel width on the 5 GHz band. On the WLC, I can see the following client performance information:Signal Strength: -49 dBmSignal Quality: 41 dBConnection Speed: 1201 MbpsChannel Bandwidth (Nego...
Aref,
Yes, in user activity I can see all users from AD, i would like to see only users from one AD groupe, in that user i would apply passive atuhetication. I dont know it is possible. I could not find any options.
Aref as u said, in Realm options ...
Hello,
Thank you very much for your response.
I have same opinion that problem is in AD, I just check that problem is not connected for ISE PIC.
It works if i have that problem, I can see users in my FMC over PxGrid normaly, but what I noticed that I...
Hello,
Thank you very much for help and response.
yesterday I solved problem. As i have doubt, problem was with NAT, I can not understand why. I have auto dynamic nat from inside to outside, when I delete that auto NAT rule, i managed to ping my ou...
Hello,
Thank you very much for answer.
Agent are correct installed and in running mode. I have primary and secondary agent same as u send link for Passive ID Agent, When I made run test to AD i got strange messages. Picture below. Could not obtain T...
