Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
The bug toolkit doesn't state when this bug is resolved...only that it has been resolved.This relates to call transfer problems in 30VIP and 12SP+ phones.Any help much appreciated.
Having problems with a PSTN call coming in to Phone X. Phone X answers and transfers to Phone Y. Before the transfer, X wants to speak to Y but occasionally this is not possible (no audio)- in this case if X blind transfers to Y then Y is connected t...
The setup is as follows:35 x 7940-------2610-------CCM/PSTNPhones run Skinny and are Nat'ed to a single IP. Can anybody tell me if there are any restrictions specific to Skinny NAT (i.e. separate to Device Weighting)...
My scenario is this.2 zones: say A & B.Zone A contains CCM 3.2 with IP phones. CCM is registered with GK-A.Zone B contains GK-B with PSTN gateways.When I call from an IP phone to the PSTN, I want to use the proxy functionality. I've got use-proxy com...
Q1- the egress q selection depends on whether layer 2 or layer 3 was used on the ingress port. If you "trust cos" on the ingress side then the qos label for that frame is based on L2 and ingress AND EGRESS q selection will be dependent on COS- the "d...
The transcoder needs to register to something- it can't invoke itself. You always need to associate it to you SCCP application that you define on the router and register it to one of CME/SRST/CCM. The document also states this, so I am not sure what ...
A transcoder will need to register to something- it uses SCCP and this is Master/Slave.You should define start the telephony-service on the router and register the transcoder locally to the telephony-service on the router (you are not really going to...
Thanks for your prompt response.I see that ccm-manager config will place the cmd inside the IOS configuration, however if I were to configure manually so I need to bother entering the command?Having a T1 PRI as a MGCP gw does not require the command ...
