Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Does anyone know if it is possible to trigger a failover in case a certain IP is unreachable? I know you can do that based on interface state but I would need to do that based on a gateway reachability.Regards,Christophe
Hello,I would like to know if there is a command allowing me to check the speed of a frame-relay PVC?I have a router connected to a service provider via a serial line. On the serial line is configured one frame-relay pvc (very basic configuration, hd...
Hello,Does anyone know what are the etherchannel parameters silent/non-silent used for?I've read the following info from CCO but I don't understandsilent : Keyword that is used with the auto or desirable mode when no traffic is expected from the othe...
No, you cannot use it only at one side otherwise one side will try to do an iBGP peering while the other will try to do an eBGP peering. And anyway, IOS is smart enough to refuse the local-as command if the remote-as matches its local AS.
The config looks good for me. I remember I've had same kind of issue with the counters on a 3750. Could you check the command "sh mls qos int fast 0/x stat" for the outgoing interface? You should see outgoing dscp with ef value. An other thing you ...
