Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
My envrionment consists of two ASA 5510 devices in active/passive failover, both v8.2(5).For years I have taken the easy way out to configure VPN access by using split-tunnel to give access to internal resources. Prior to the ASA I confugured my PIX'...
I'm struggling to address an issue where as a policy I have internal virtualized/clustered servers on reserved DHCP addresses on a separate VLAN, and occasionally there is a situation where by the guests change hosts and end up on another VLAN (for w...
I am looking some advise on what direction I should persue for an expansion to my network.Currently I have a Cat4506 chassis with a Sup II+ engine and one WS-X4232-RJ-XX linecard with the WS-U4504-FX-MT daughtercard to provide uplinks to four Cat2955...
I have been struggling to come up with the proper config to do a NAT of an incoming VPN tunnel to a VLAN on my network that I hope either someone has done or can shed some light on.I have an ASA 5510 with an IPSEC site-to-site tunnel to a partner net...
I have scoured the Cisco docs for a solution, but I still don't know how to solve my problem.I have one Cat4500 with a SupII+ engine in my LAN that is set as Server, as well as another similar 4500 set as Client. There are about 30 other Catalyst swi...
A sincere Thank You to all who answered.Peter was the first who suggested to check the password on the Server, and that turned out to be the problem.Why on earth would you create a VTP Domain and password the server and not the clients is beyond me.A...
I am considering MAS auth for clients that don't support other methods. From what i've read, there are other ways, but this seems simple enough.Thanks to everyone for all the help.
This seems to be easy, but I am even having problems getting CiscoView embedded installed on my Catalyst. It says that I HAVE to install it into the "cv" directory, but my flash card doesn't have a "cv" directory and I can't find a way to create one ...
I understand what you are trying to do, but I think you are considering something more of what a proxy server does. If you want to filter HTTP, you wil need to use Websense (or the other one). You want the PIX to respond to the first connect of a web...
