Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Let me start out by saying how disappointed Phone Designer no longer works. That was a GREAT tool. I used Phone Designer to put a personal, family picture onto the phone of a senior staff person a few years ago. The image stayed on his phone even aft...
I have replaced my laptop with one running Windows 8. On my previous laptop running Windows 7, I used several Cisco Apps that I can't seem to install or run on Windows 8 such as Click to Call, Unified Video Advantage, IP Communicator, and VMO. Is th...
I have a Cisco2811 SRST/K9 router with a four port FXO that is part of our phone system. It won't ping to anything on the network except for one particular switch. I can ping that switch (but nothing else) and that switch can ping the router and te...
I have a vendor trying to connect to one of my servers. To this point, he's been able to connect using a specific port. I created an entry in my access list - access-list inbound permit tcp host xxx.xxx.xxx.xxx host 167.21.xxx.xxx eq 397. He was...
I have an old 2621 router that loses the config every time it loses power. I assume that there is a replaceable battery. Can anyone give me some guidance? I assume that I'll have to power it down - replace battery - rebuild (again). Is it a stand...
Same. It's a new phone of the same model. I'm not sure how or where Phone Designer stored the image or ringtone selected because I don't see it on the CallManager. It was pushed from Phone Designer to the phone and my only thought is that it was stor...
I uninstalled VMO and upgraded to Unity Connect 8.5. I still get the same error when trying to connect to Outlook 2010; however, it seems to work just fine. So, I'm just going to ignore the error message.Thanks all,Andy
I'm having the same problem. I am using Cisco Unity 7.0 Build 7.0(2). I can ping it by name, so name resolution works fine. I get the same response: "Unable to find voicemail server. Make sure server name is correct." If I ignore the error and ...
Well, it works. I assumed that if I configured the swichport for mode trunk, it would pass all VLAN's, but I had to specifically put it in switchport access VLAN 101. I was just being stupid, I guess.
