Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have the following PPPoE configuration on a router: aaa new-model
!
aaa authentication ppp default group radius
aaa authentication dot1x default group radius
aaa authorization network default group radius
aaa accounting delay-start
aaa accounting ...
I'm having a problem with the labels showing on the phone, but not on the expansion units. I have a phone with 1 normal line and the rest of the lines monitored.
ephone 47
mac-address 381C.xxxx.xxxx
ephone-template 3
type 7975 addon 1 7916-2...
Hi there!
I am experiencing a problem which I suspect involves an issue with route advertisement.
The setup is as follows:
Device A 10.0.154.2/25
gateway 10.0.154.1
Router A interface 1 10.0.154.1/25 interface 2 10.0.154.250/29
interfac...
HiI've changed the VPN IP pool on a previously functioning VPN setup on a Cisco ASA5505, I've updated IP addresses everywhere it seemed appropriate, but now the VPN is no longer working. I am testing with a Cisco IPSec client, but the same happens wi...
HiI have the following setup:Cisco 2621XM with NM-HD-2V and VIC2-2BRI-NT-TEIOS 12.4(4)TCallManager Express 3.32x ISDN NT connected to PSTN via BRI (in port 0).I'm trying to achieve the following:Outgoing calls work if dialed from phonesIncoming calls...
Thank you, Giuseppe. In fact, they do not exist. These attributes are from a different setup. I have created them now and assigned the IP address to the Loopback instead of the client interface. I will test again tomorrow as the router is at a diffe...
Thank you.
I have configured BLF. The buttons on the phone still function properly (as BLF this time), but the expansion modules are blank (bright blue screen with no images, but the buttons appear to function as speed dials when pressed).
I have...
10.0.155.233 is a router sitting in front of 192.168.1.64/27, so my reasoning was that if I can't reach that, I won't go further.
"show ip route" gives thousands of pages worth of output. There are about 650k entries in the BGP table :-).
Somehow...
Thank you, Michal! The problem is now partially resolved.
I can confirm that adding a default-metric solved the route redistribution problem.
I'm receiving all the BGP entries over EIGRP now, but I'm still unable to reach 10.0.155.233.
I suspec...
