Hi All,We are getting ready to deploy AP's in our warehouse and they will be mounted in quite inacessible heights once installed. As well as setting up AP redundancy I had an idea to run two CAT6 cables to the AP, one for the network and one for the ...

Hi All,Just wondered if anyone had measured throuput on a WS-X4148-RJ module in this switch. We ran a test on an idle network and were only achieving between 62 & 72 Mbps. The old switch we used here a 2980G was averaging 88Mbps.

Hi,I'm trying to get a Cisco 803 to maintain the time if the power is cycled but it always reverts back to factory time. I notice there is no command like on the 1600 to use 'calendar' to set the hardware clock, Is there a way to set the clock perman...