Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,Can I see if anyone has any clue why there is no voice path when i cross router for external calls.We are using MGCP controller routers on CM4.2(3).This is our setup now, we have a Nortel PABX which has 2 QSIG connections, each to Router 1 and Rou...
Hi all,I am reading through the Cisco data sheets on the new cisco attendant consoles. And one thing i found confusing is that it says the dept supports up to 150 phones and the biz supports up to 500 phones.But i'm curious about what would happen if...
Hi,I am trying to configure a H.323 gateway and got external calls working, but not incoming calls to the IP phones. Somehow it is not matching the dialpeers to pass to the CCMs.I did a debug voip ccapi inout and got this errors as attached.May 23 17...
Hi,I have a 4506 with a module with 10/100 ports, WS-X4148-RJ45V. And when I plug in an 7961G-GE, there is no power. If I use an Power cube, the phone will come up and will register successfully.If I connect a 7961G (without GE), the phone can power ...
Hi,I am having a problem where i have a QSIG connection between a Cisco 3845 and a Nortel Option 11C PBX. This router is configured as H323 registered to a CallManager 4.2(3)When I use an IP phone and dial to a nortel phone.The nortel phone is ringin...
Hi Rob, busy researching the new CUCM6! Actually, we were not looking at the Cisco AC 1.4, because it did not meet our requirements as it does not have the advance features such as call queuings, reporting, etc. Which is why we were looking at the D...
Hi Martin,Not too sure what you need in terms of justification but the key thing is that the end of Maintenance Release is May 15, 2009. http://www.cisco.com/en/US/prod/collateral/voicesw/ps6788/vcallcon/ps556/prod_end-of-life_notice0900aecd806f41d9....
Hi Peter,This is very odd.I'm not sure what is wrong. But to isolate, can you just create a Route pattern that use the ICT as the gateway. (Do not use a route group or route list here)Try to dial this route pattern to see if you have your 00 prefix a...
