Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I keep getting this:"Processing incoming UPDATE packet" on my WAN stub routers. I would like to cut down on the traffic AS MUCH AS POSSIBLE!!! I have a DMVPN and if it becomes unstable, its hard for it to catch up. I already have the "eigrp stub co...
Using hte following configuration, I can connect and authenticate. I can also configure the IP address manually and ping the gateway 10.205.2.1. I''ve pasted the configuration. What am I doing wrong?
Here's the config, I can't see the ssid from my laptop but I can see others.hostname test!boot-start-markerboot system flash:c181x-advipservicesk9-mz.124-9.T.binboot-end-marker!logging buffered 128000 debugginglogging rate-limit all 500!clock timezon...
In the past, I've always used NAt with overlap but in the documentation with the ASA5510, it clearly stated to use NAT with PAT to accomplish NATTING when you have more inside addresses than available outside addresses. Which one is more secure and ...
We have everything working the way it should with one exception. We have a ASA5510 with a SSM module. So far we have been able to get it all working but with, again, one problem.When we configure, "same-security-traffic permit intra-interface" and ...
You really cannot use EIGRP effectively over the WAN. I was managing a 500 node DMVPN with a a redundant 6509 core. The results were unbelievable. The 1811's hanging off of the cores through the DMVPN's were crazy. Every time a change occurred, i...
cisco(config)#int vlan 1cisco(config-if)#no ip helpcisco(config-if)#no ip helper-addresscisco(config-if)#int bv1cisco(config-if)#no ip helper-addresscisco(config-if)#int dot 0cisco(config-if)#no ip helper-addresscisco(config-if)#^Zcisco#wrthen I did ...
nevermind, I found the answer. You have to setup the guest mode to connect while browsing. Also, windows doesn't even show you connected if you list it as an infrustructure ID in XP. Additionally, you have to set it up as automatic with the right p...
