Hello,Is it some ways to tune the Entry IP address, that is advertised to CDP neighbors?(Problem is that router in cdp advertised the IP in vrf, but not real address)Or what is the algorithm the system choose what IP address to advertise to CDP neigh...

Hello,As IGP I have to use ISIS.The problem is:when on Router with ATM interface I use "encapsulation aal5nlpid" - the ISIS works, but IP doesn't work ;-((I can see right routing table with routes from isis and all isis neighbors in UP state but pin...

Hello,In my configuration I try to use PBR in VRF.I want that one part of traffic goes via 192.168.0.1 and other via 192.168.0.2 but it seems traffic goes only via default-gateway. - 192.168.0.1.Question is - is it possible to use PBR in VRF?!!!!!!!!...

Hello,I've got 8 c3550 connected via GBIC1000T interfaces to a ring. There are about 30 Vlans. At one moment (after restarted two switches, no software was changed) UDLD have started to disable ports (the trunk ports to other switches in the ring) on...

Hello, I've use IOS (tm) C2600 Software (C2600-JK9O3S-M), Version 12.2(23),I've tuned DHCP Manual binding as was on the example, but th edhcp server doesn't give the IP from manual-binding pool. the config is:!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!ip d...