Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can anyone tell me how to ask the telco (AT&T) how to properly provision a BRI circuit for Voice? We need to have the ability to receive voice calls on either directory number. They can't seem to get it right. For example: If we receive a call on di...
Any progress on the cme caller id name delivery issue when the telco is sending it in the facility ie field? If not, can I map the Facility ie information to display ie by using another router?Router 1 would be connected to the telco PRI and a second...
I have two 2811s in a tandem configuration. One is the border router with an atm aim, two VWIC-2MFT-T1 and 2 atm pvc's connected to the internet. The other 2811 is being used for voice services. The one being used for voice services can be accessed w...
Hi everyone, We changed our router from an IAD-2421FXS running 12.2T11 with incoming T1-CAS FXO to a 1760 router with a MFT-T1 running 12.3T11 and our caller-id info dissapeared. Configuration of incoming FXO ports is identical to the IAD but the cal...
I have been searching the net and I found this from Intel. It is for their conference statino. It looks like it could work with CME.Set MTERM to 2Maximum terminals set to 2. This tells the switch that there is 2 terminals active on this line.Set MAXB...
Yes, I need the DID number in order to properly route the call.... Anybody out there have any clue to how to solicit proper configuration to SBC (the new AT&T) will be greatly appreciated.To Recap of what we need:1 BRI Circuit2 or if possible 3 Dire...
I forgot to mention that we had DID on the circuit and after the telco changed the configuration to CACH EKTS they took it out. Now what I receive is the ENDPOINT ID. Very weird. I wish cisco could come up with a provisioning document for BRI on CME...
