Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Suppose I have 4 identical MS225 switches around my building, if I want these switches to do my L3 routing among our various VLANs, I think I have to assign an SVI (a Layer 3 VLAN interface) on each switch.Question is -- for the clients connected to ...
The different terminology used in these new SB switches is so confusing to me, and I'm having a hard time wrapping my brain around how to set up our simple environment.The SF302 is replacing a 2950-12 switch; the existing 1721 router config isn't cha...
Switched to L3 mode in telnet menu mode. After a reboot, the switch gets an IP address from the router with DHCP.When I try to change the IP address to static (VLAN1) The subnet mask becomes editable, but I can't change the IP.VLAN1 isn't editable on...
We're running Callmanager Express with voice & data VLANs and QOS. I need to connect a small outbuilding with fiber, it will have 2 phones and 2 computers in it. Can I get away with a Catalyst 500 Express layer 2 switch in that building to handle the...
Thanks to all for replying, I didn't receive notification of thread replies hence the delay.It sounds like in my structure, I might be better off having each switch do its own thing (multiple VLANs), since I can't logically break out the areas to hav...
Don't worry, according to the earlier post they're just 3 or 4 months away!.... from maybe announcing a possible roadmap for future development... maybe. (Of course, as is the custom, it'll only be in restricted beta firmware for 12-18 months after a...
Layer 2 isolation is only in bridge mode, not Meraki NAT mode, so there you go.You could turn on Meraki NAT so everyone gets an isolated subnet to themselves, and then add an ACL to permit traffic to just the printer IP address on the LAN, and then a...
You could create a CTI route point that defaults that extension to unity voicemail, and create a unity box that plays the message and then hangs up. Upload the WAV file as the greeting and you're done.
