Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, well the question is simple.
I had created a couple of dashboards in Prime, but none other users is able to see them.
They are not in the tabs.
Only system defined dashboards a visible to all users?
best regards
Hi, i'am trying to figure out if it is correct the amount of devices that are shown in each report.
In Inventory->Network devices i have 450 devices, but when i check the reports they show a diferent amount of devices.
PSIRT: 447
HW EoX: 355
SW EoX: ...
Hi, the PS2-1300Watt AC of my Cat6500 (the old chassis version hardware ver3.0, it is not the E) is out. We buy another one, but this one has 4000Watt.The CatOS version is 6.3(3). And supervisors 2.We are running over non-redundant power configuratio...
Hi, iam having a communication problem between the NAM and the switch, with the following message in the NAM web page: Performing SNMP test from NAM (9.8.130.254) to switch (9.8.132.25) Access to the switch failed. This may be due to the switch's SNM...
Iam getting an authentication failure trap from several of my devices.I know that this kind of trap is generated for an non authorized snmp query to a device.This general trap does not include the IP address of the equipment who is trying to walk the...
I had a similar issue before. I was using auth/proxy, and it simple does not work for me.
I finnaly open the ports on firewalll in order to let prime access directly to internet.
Hi Marvin, i've checked EEM on ASA, and it cannot be done that way. Also, ASA only support one and only one syslog destination.
I'm trying to figure out if the orinal propouse from r.westman.
On the other hand, PI only supports 2millon syslogs, after...
Hi Marvin, thanks for your response.
The issue that i have, is that Security Team, has activated info level security logs for "spoofing" as an example. That kind of logging gerenate a lot of logs for ASA.
They have a log collector for that, but also ...
Hi, no, the log collector were not down when i get this alarms.
I have checked in "Logging Categories->Global->TACACS Accounting", the box for "Log to Local Target". But NOT checked "Local Target is Critical"
ACS instances are all configured for "GLO...
