Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I want to run MPLS TE My PE routers have 2 STM1 links connectd to P routers If i want to reserve 200Mbps for my TE tunnel while 2 pos interfaces are not part of POS-channel RSVP will see that there is not enough BW in case there is 300 Mbps availabl...
HiOn my MPLS netwrok that use GSR and OSR routers , MPLS mtu is set to 1550 when i ping from one OSR to other OSR packet larger than 1500 bytes are droped but ping with more than 1500 bytes for trasit traffic is OKI mean i can ping from one OSR to de...
I am working on a network running MPLS MPLS MTU 1550 is set under gig interfaces while using show cef interface it shows that IP MTU is 1500 Will this cause some packet drops ?Isn't it better to have same IP and MPLS MTU or not thx
I want to establish a fiber connection between CSS11506 and 3750G I am using SPF 850nm using orange fiber cable But connection is not up When i connect from one gig interface to other gig interface on css11506 using same cable and same SFP port becam...
If you tell me which parametres you need about interfaces in between All traffic are tagged Transit traffic is ook when i ping with 1500PIng Localy terminatiing traffic (like Loopbak) wit 1500 fails
I am using 7600 OSR as PE These OSR are connected to GSR routers using multiple POS links7600 dose not support POS-Channel I want to have TE tunnel with 200Mbps But because there are multiple POS links and each one has 150Mbps , TE tunnel will not be...
Users who initiate PPPoE session from using PC have no problem Only users that initiate PPPoE session using their modem and do NAT on modem (because more than one PC want to use DSL service) have problem
