About prash723

prash723 · 07-14-2022

We have 2 core switches (cisco C9407R with network-essentials License) and 8 access switches. We don't want to use Stackwise Virtual as it requires subscription based Network Advantage License. What will be the best alternative to achieve high availa...

prash723 · 12-15-2021

We have 2 wan links on the Firepower 1010 both are pppoe. We want to use wan as below no failover is required.wan 1 for subnet 172.16.100.0/24 + 172.16.50.0/24wan 2 for subnet 172.16.150.0/24is it possible? as we can not set next hop IP in the route ...

prash723 · 11-19-2021

We have below call flow CUCM>>(SIP)>>CUBE ISR3441 >> (SIP) >> Service Provider. Service provider tested the connection, Please check in the screenshot. CUBE IP : 192.168.3.50Service Provider IP: 192.168.3.1 please suggest the configuration.

prash723 · 11-17-2021

I want to change default gateway of cucm. When i tried to save change it returned with below error. The requested command returned a result code of 4. Non zero results indicate a failure. Kindly check sceenshot.

prash723 · 11-16-2021

Model: Cisco Firepower 1010Threat Defense Software: 6.6.5-81 ===============[ System Information ]===============Hostname : SHCC-FPDNS Servers : 208.67.222.222208.67.220.220Management port : 8305IPv4 Default routeGateway : 172.16.100.254Netmask : 0.0...

prash723 · 07-15-2022

Thank you All of you for your suggestion. I will go for HSRP in core switches. I have below doubts. ***connectivity between Core Switches and Access switches.*** I have 6 vlans spread across all access switches. I want to connect two links for each a...

prash723 · 12-17-2021

Hi Marius, Thank you for your reply.I am currently on FDM 7.0.1If it requires latest version I can upgrade to it. Can you please share me the procedure? Regards, Prashant

prash723 · 12-16-2021

I found the solution:Go to the expert mode then root access Root# pmtool disablebyid tomcatRoot# cd /ngfw/etc/sf/Root# rm ./state.yml && rm ./agentStore && rm ./agentCertsRoot# pmtool enablebyid tomcat

prash723 · 11-19-2021

Hi Roger, I have configured rest invoirnment except SIP between service provider and gatewat. I am receiving the calls on but it is getting disconnected after 20 sec and only one direction sound. This is my gateway configuration.

prash723 · 11-17-2021

Thanks Scott for the quick response. set default gateway 172.16.50.254 This is invalid syntax I can see below systax, is it correct? admin:set network gateway ?Syntax:set network gateway addraddr mandatory IP addr to be assigned Regards,Prashant

Member Since	‎10-11-2017 11:23 PM
Date Last Visited	‎07-20-2022 12:01 AM
Posts	27

User Statistics

User Activity

Design Consideration: Redundancy for cisco C9407R

Firepower 1010 PBR

CUBE to Service Provider SIP Trunk

Chnage Default Gateway of CUCM in OS administration

Cisco Firepower 1010 FDM not able to register Smart license

Re: Design Consideration: Redundancy for cisco C9407R

Re: Firepower 1010 PBR

Re: Cisco Firepower 1010 FDM not able to register Smart license

Re: CUBE to Service Provider SIP Trunk

Re: Chnage Default Gateway of CUCM in OS administration