Hi, At this moment we have at a subsite a WS-C3550-24-EMI. The gigabit interfaces are empty. We need a extra switch in the serverroom to connect servers and uplinks to other swithes. What is the ideal 48 10/100/1000 switch. Do we need to stack or upl...
Hi, Do you have any idea if VLAN information can be provided over BILAN network? Bilan stands for "Belgacom interconnection of Local Area Networks" -- Belgacom is the telecom provider in Belgium. They have 7204 routers intalled at our site and 2600 a...
Hi, I have a HP server with HP network Configuration Utility 7.86. I've selected for the teaming properties : Team Type selection : Automatic Transmit load balancing :Automatic On my 2950 switch both ports are configured for active channeling : inter...
Hi, Can the two 2 10/100/1000Base-T ports on a WS-C2950T-24 be used to connect a server in teaming on instead of using it as uplink ports ? These switch will be used standalone at an SMB customer.Regards,Kristine
Is it possible to setup ISDN/PSTN connections to non cisco-routers but to ordinary ISDN/PSTN modems?Most of the time customers connections are based on username/pwd. I don't succeed to setup such a connection from a cisco 2600.All help is welcome
Our distributor offered me an WIC-2AM (in fact for the 2600) but he told me it was compatible. Is this correct ? If so is there no card for the 2600 that can do both ISDN and PSTN dialup ?
because we also have IPSEC connections, I thougt of using an ISR. Any ideas for this environment? Or should you recommend to split up dial-up connections and IPSEC connections ?because I'm not used to make ISDN connections with a router - is there so...
Ok. Thanks al lot. Do you have a doc that describes this ? I assumed i had to balance with the mac address because of the layer 2 etherchannel but i changed it to ip-address and it works also. Is this because the Transmit Load Balancing is done by th...
