About matthiaskoehler

matthiaskoehler · 05-03-2004

Hello,Because this is far too much ahead for me as CCNA maybe you can help me with my problem:I have two Routers, a 1712 and a 1720. Both are connected to the Internet using DSL, PPPOE and are doing NAT.I have established a GRE Tunnel encapsulated in...

matthiaskoehler · 06-20-2005

Yes, if you are use PAT (overload). You need a static mapping for smtp (tcp/25), outlook web access (tcp80/443) traffic. Otherwise you won't receive any mail and access the web-client from outside ...

matthiaskoehler · 06-20-2005

If you are using PAT you might need to add this:ip nat inside source static tcp ip_of_your_router 23 interface your_dialer 23

matthiaskoehler · 06-20-2005

I'm not 100% sure, but this should work. The Module is quite old and the feature u are looking for was already mentioned in the old datasheets ...However, i haven't tested it with this version (We use this module in 2811 with IOS 12.3T ..)

matthiaskoehler · 06-02-2005

Assuming that you use nat/pat and a dialer interface. If you do not have a dialer int replace the dialer0 with your outside interface:ip nat inside source static tcp 192.168.1.101 3389 interface Dialer0 3389

matthiaskoehler · 06-02-2005

It is clearly stated in all WIC-1ENET documents that this module works in 1700 series routers ONLY. Not all WIC and NM Modules that run in 1600/1700/2600/3600 Routers will run in the new ISR's. Refer to the 1800/2800 documentation (dataheet) to find...

Member Since	‎04-18-2004 11:43 PM
Date Last Visited	‎08-18-2017 03:51 AM
Posts	26
Total Helpful Votes Received	23

User Statistics

User Activity

VPN Routing Problem

Re: EXCHANGE 2000

Re: telnet on cisco 1711

Re: Ios for 3620 and nm16-ews

Re: How to open port for remote desktop connection?

Re: WIC-1ENET in new ISR routers not working/