Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have offices that we are trying to connect to our main office using cisco vpn client ver 4.6. The offsite location has a dsl connection to the internet and a hub in place to allow for multiple computers. I can only connect one computer at a time ...
i have a catalyst 4006 with 4232 L3 blade and supervisor engine 2. we are using catos for the supervisor and ios for the L3 portion. we have created a vlan that will connect to another agency network, they have a subnet mask 255.255.255.240. my ne...
we are setting up a 4006 multi layer switch. we have two vlans set up: vlan26 and vlan162. we are using the supervisor engine 2 w/ catos. on the l3 blade we have a router connected to a port designated vlan162, from a port on the l3 blade designat...
I have a catalyst 4006 L3 switch which uses catos for the l3 ports and ios for the l2 ports. the 4006 as a supervisor engine 2 blade and a 4148-rj blade. I would like to remove the catos from the switch and use only the ios. Any problems with doin...
I would like to use my 3640's modem bank to allow users to dial-in. It was used previously as a dial-in backup solution but has not been used in years. Below is my current config for the modem lines. Should that be sufficient to allow someone to d...
We are using default configs on the dsl hardware. we only get one ip from our isp. can we make config change on the concentrator to allow multiple connections or do we need to focus on the dsl router and setting up pat? I would think the latter bu...
I will ask if they can enter routes back to our network. The answer is yes to your final statement, they have allocated a specific number of ips for our organization to access resources directly on their network. What we are trying to accomplish is...
the outside agency has a 1720 router directly connected to our L3 blade. the address of the 1720 is 162.143.16.225/255.255.255.240. I made vlan 162 on my 4232 L3 blade (actually a port-channel1.162) with ip 162.143.16.227/255.255.255.0. My network...
I had a similar problem a little over a year ago, so I'm not sure if my memory is 100%. I believe what fixed the issue was configuring the ethernet port on the bridge and its connecting port on the switch to 10/half. I may have upgraded or reloaded...
