Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,i want to know if it is possible to Configure a Cisco 800 Router (803 or 801) as a Least Cost Router for ISDN?So that it connects to a different Provider at a special time?Is it possible with other Cisco Routers?Thanks
Hello,I have some old Modules from a 5500-Series.Now I want to write down the Serial-Number of the Modules. (5201, 5213a,.....)Where are they to find?How do they look like (xxx-xxx-xx-xx-xx)Do you know a page with pictures where it is explained?Thank...
Hello,i only have the possibility of telnet to configure a ap1231g acceesspoint.Now i have to check the mac-filter configuration because it doesnt work properly.How can i configure the mac filter over telnet?I was not able to find a configuration exa...
Hello,i need routers with specific requirements, but its very hard to look at all routers at the Cisco.com homepage to find aout what are the cheapest to fulfill these requirements. Who can give me a tip how i can easily find out what i am searching ...
We want to install a new AP1231, and we want to use Vlans to divide Voice from Data.But their seems to be only one possiblity to do this, and thats with different SSIDs.Or is their an other possibility?I think at the older accesspoints is was possibl...
There are 2 stickers on the supervisor.Both have a 8 digits long number (XXXXXXXX).But there some yellow stickers with other numbers, but no 10-/11-digit numbers. There also are no leading zeros.I dont have a working 5000/5500 Chassis, thats the prob...
Thanks a lot for your help!Is there any other module for other routers which fullfills the requirement of 16/8 Port Fast Ethernet Fibre??Do you know any other solution?
now i tried to upload the ios by xmodem,but there i have the same problemIt always stops at the same number of transfered bytes!What could the problem be?Can I solve it anyway or should Igive up hope!Does anybody know a solution for my problem?
we have the same problem, but the cut and paste solution doesn't solve our problem.We loose connection after making a change at the configuration or rebooting the bridges!What could be the problem??It works after entering the wep key but, if we then ...
