About Samuel

Samuel · 04-05-2023

Im having issues with changing the cost of a learned ospf route. the route map pics up the route but the set metric command isnt working. Am I missing something? ip prefix-list DEFAULT_ROUTE seq 5 permit 0.0.0.0/0route-map test permit 10match ip addr...

Samuel · 05-15-2019

Hi guys Ive been noticing that my DMVPN setup has been having intermittent issues with sites that are in transport mode.Every now and then I would have a site go down and would have to clear the isakmp sa session for it to come back up again. I have...

Samuel · 12-05-2018

Hi guys Im having an issue whereby my DMVPN has peered with my spokes and OSPF neighbors have formed adjacency but for some reason the routes are not showing on either end. When I look at the database I can see them but not in the respective routing ...

Samuel · 10-24-2018

We currently have our ISE administrators using AD external identity sources to log into the servers however weve noticed that even with the super user setup we are unable to have full control. Is there something that can be done to allow AD admins to...

Samuel · 09-03-2018

Last night we had a power outage and our switch booted up with power from only one PSU. Now the switch has a steady amber status light and I see the below message. system minor alarm on power-supply 1 power-output-mode (raised 16:18:36 ago) system ...

Samuel · 04-05-2023

Well said, but if I use per destination instead of per packet load balancing it should work.Anyone else care to comment?

Samuel · 04-05-2023

So guys Ive decided to let both default routes have the same cost, making both default routes present in my downstream routers. I only hope that this will have the desired effect of load sharing internet traffic between the two firewalls.Thanks every...

Samuel · 04-05-2023

If i were to change the cost on the interface, it would affect both routes and still not get the desired outcome.

Samuel · 04-05-2023

The default routes are e2. The router is ospf neighbors with both firewalls in the same broadcast segment. This router is a secondary dmvpn hub. We also want it to pass traffic via our secondary internet hence the reason to alter the cost.

Samuel · 04-05-2023

we have 2 fortigate firewalls with static routes being redistributed into OSPF. One firewall redistributes with a higher cost than the other. What I would like to do is to change the cost of one of those default routes for one of my downstream router...

Member Since	‎10-13-2017 01:33 PM
Date Last Visited	‎04-18-2023 06:25 PM
Posts	24
Total Helpful Votes Received	2

User Statistics

User Activity

change the cost of a learned OSPF route

DMVPN tunnel goes down and would have to clear isakmp sa for it to come back up.

DMVPN OSPF routes in database but not in routing table

ISE external identity source administrator account limitations

Catalyst 6800 Alarm

Re: change the cost of a learned OSPF route

Re: change the cost of a learned OSPF route

Re: change the cost of a learned OSPF route

Re: change the cost of a learned OSPF route

Re: change the cost of a learned OSPF route