Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, I am trying to configure an 827 running 12.2(8)T5 with static NAT.The WAN IP is provided via DHCP on the ATM interface and the LAN is connected via Ethernet0 to a 192.168.0.0/24 subnetI want to forward ALL traffic hitting the WAN interface to IP ...
OK currently the network is setup as follows:Zyxel SHDSL Router --> Linksys Router --> 10/100 Switch --> PC's x.x.x.145/28__________x.x.x.146/28____________________192.168.1.0/24The Linksys router is running inbound one-to-many PAT (eg. x.x.x.1...
I have an 837 connected to internet and LAN. The WAN interface receives an IP address via DHCP from the ISP. The LAN is on network 192.168.1.0I want to setup NAT to redirect port 8080 on WAN interface to 192.168.1.250:80 on LAN.Have had a play but ca...
No that is not what I am trying to achieve. I would like to forward ALL inbound traffic from the internet to a specific internal IP address.It is a simple setup that even the cheapest routers can achieve but the command I usually use is not accepted ...
hi, I have read somewhere on here that using public IP's on loopback interfaces for routing and NAT purposes can cause problems. If this is true or not I cant say but I will give it a go.
