Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear allI have a 1721 router with WIC-1T connected to framerelay network, when the modem is powered off and then powered on again serial interface becomes down/down and not becomes up again except i unplug & plug the serial cable connecting the modem...
hello allwe have a Call Mnagaer software version 4 and we need if there is a critical situation like a fire or something to call all phones and have auto answer on so that an administator or the one who notice the critical situation can say his/her m...
we have three routers, mesh connected two of them has an ethernet interface and each interface is connected to a switch, the two switches must have the same IP subnet, how can we route traffic
I have a cisco 3640 router with NM-HD-2V with 2 VIC-4FXO and IOS 12.3(11)T5 connected to a PANASONIC PBX.the problem is when any call is hanged up the FXO port doesn't disconnected and remain connected although the 2 endpoints are onhook.i have anoth...
HiThank you first for your valueable recommendationsI did that before, i removed the configuration of BRI at all and i maintain the configuration of the serial only.and the same problem exist.
Find bellow the configuration on the routerThe IOS image is c1700-y-mz.124-5a.binBuilding configuration...Current configuration : 1295 bytes!! No configuration change since last restart!service timestamps debug datetime msecservice timestamps log dat...
we are not allowed to use any more products, I think the call manager should support such a feature it is not a big deal as i think, but as a reply for u call manager doesnot support paging, i think it is callmanager express that support itI think ot...
thanks for ur response, but I tried shared line and when I tried Auto answer it was not supported. but any way thanks very much 4 ur time, and I will try the link u write and i will give u a feedback
