Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
is it somehow possible to install the RADKit on the ESXi Version of Catalyst Center? It seems the "Support Services" Package is not available for the VM Version of the Catalyst Center. Any change to install it anyway?
Best regards,
Hello,when a SSID is tunneled in L3 roaming mode to a concentrator, the concentrator acts as Radius authenticator. Which will be the source interface / IP of the Radius requests? Is it the WAN IP of the concentrator (in routed mode)? Or is it the Vla...
Hello,is the option VPN mode "enabled" under "VPN Settings -> Local networks" needed to advertise a local subnet to a third party VPN peer. The main purpose should be to advertise only the some subnets to the third party VPN and not to the Meraki Aut...
Hello,I want to enable MACsec with PSK between the Core and Distribution Switches (C9600 and C9500) which are stretched over darkfibers.The link speeds are 10G, 40G and 100G and I noticed following from the configuration guide:Use Extended Packet Num...
I had a similar issue and I think the only solution is MS 17.2.2Fixed a bug that caused an unexpected LACP discarding state when connected to third party firewallsAfter an upgrade from 17.2.1 to 17.2.2 everything was working regarding LACP port-chann...
Is the co-existence mode a good choice for a migration from Prime Infrastructure to Catalyst Center? The plan is to do a granular migration and then turning Prime Infrastructure off and Catalyst Center will be the new and only system.
Hi,
is the onboarding working with this setup? I‘m looking for the same. How will the root CA installed on the cEdge? Will it be doenloaded from PNP during first contact? Do you have some special settings in vManage?
best regsrds, Stefan
