About allalamine

allalamine · 02-16-2023

Hello, I'm trying to connect a A99-4HG-FLEX line card to ASR9910. Only four 100G ports are available, anyone knows how to enable the remaining 40 tengig ports ? RP/0/RSP0/CPU0:lab#sh int desc Interface Status Protocol Description-------------------...

allalamine · 10-31-2022

Hello networkers, In MPLS L3VPN, can we advertise a route to eBGP neighbor only if there is at least one ISIS neighbor up ? (ISIS is the IGP and running in GRT). PE is an ASR 9010. The neighbor is dual-homed and the advertised route from PE to neighb...

allalamine · 09-19-2018

Hi All, I'm referring to RFC 4787 about NAT. I could find that Cisco's default NAPT mapping is endpoint-independent. How about filtering, is it endpoint-independent ? address dependent ? address and port-dependent ? Many thanks

allalamine · 08-02-2018

Hello, I have an IPsec tunnel going through an MPLS VPN, between two CEs. The IPsec destination is received over 4 links what means that I have 4 active paths to reach the tunnel destination (BGP multipath used) Will the traffic be load shared ...

allalamine · 07-03-2018

Hello, Is there any way to filter routes from ISIS database to routing table on ASR9k ? It is possible on IOS XE, Huawei, Nokia and other platforms. Thanks all

allalamine · 02-16-2023

Clear, many thanks Sam

allalamine · 02-16-2023

Thank you Sam, Does it support oversubscription ? can we use all ports even if it is limited to 400G ? It says "Oversubscription will be supported on these line cards in a future release of IOS XR 6.2.x train.", but in the second link, port configura...

allalamine · 10-31-2022

Thanks Sam if rib-has-route would work with a prefix-list containing hosts like RR or NMS which are always up

allalamine · 10-31-2022

Thank you To use this, I need to create as many IP SLA objects as ISIS neighbors. each IP SLA will ping a neighbor. Gonna be hard to maintain as we should update config whenever we add/remove neighbors .. also convergence will be longer ..

allalamine · 09-13-2018

Many thanks @lespejel. I think the only solution is to use IPsec in transport mode. We'll expose the end hosts IPs, but that's not a high risk as in this scenario we're running IPsec on top of MPLS network.

Member Since	‎03-17-2015 04:33 PM
Date Last Visited	‎02-16-2023 11:47 PM
Posts	11
Total Helpful Votes Received	5

User Statistics

User Activity

A99-4HG : tengig ports doesn't show up

Conditional advertisement in eBGP based on ISIS status

NAT on ISR routers

Load-share IPsec traffic over MPLS

ISIS route filtering from database to route table on IOS XR

Re: A99-4HG : tengig ports doesn't show up

Re: A99-4HG : tengig ports doesn't show up

Re: Conditional advertisement in eBGP based on ISIS status

Re: Conditional advertisement in eBGP based on ISIS status

Re: Load-share IPsec traffic over MPLS