I am new to VPN. The idea is to have remote client VPN back to the home office from any place in the world. We are using laptop with latest Cisco VPN client, accessing our PIX515 in the home office. I am able to see the shares on the network, we are ...

I had to password recover my soho97. If I use the CRWS to access the soho, can I set back the factory default config.?So I can start fresh, or does someone have a copy of the baseline config.Thanks

This is a newbie question..trying to get tftp server to work from the 2610.I have a pix515 that stores configs ok, on a tftp server.I tried to use the following command to setup the tftp in the 2610.tftp-server 192.168.5.23Then i get a warningWarning...

Hello, I'm new here.We have a AP1100 set with wep 40bit, and nothing special, other then the defaults. The dhcp ip's, are not being re-issued, when we disconnect from the AP.Our network flows like thisT-1 --> 2610 router --> PIX515 The pix has two t...

While launching Cisco view, I get thefollowing error.:Please grant permission to launch Cisco View.Quit the browser and try again.Where would I grant this permission, using WinXP, and I.E. 6.0Thanks