Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,We recently had a failover test between between our ISP 1 and ISP 2. The failover portion worked fine via the IP sla's but we were unable to pass traffic through ISP 2. I believe the issue is due to the switch we have the ISP connections coming...
Hello,Running into an issue of we are not able to get the 3750 running version 12.2(55)SE3 to communicate with ISE. I'll post the current config we have here below for assistance: aaa new-model
!
!
aaa group server tacacs+ ISE_TACACS
server 192....
Hello,Looking for some help on this trunk config I maybe don't understand the service instance configuration on a Ncs 520 but I'm unable to see the other N520 connected to this device with these configs plugged into each other. Please let me know wha...
Edit: issue was not related to networking. The MW interfaces where missing some settings. Problem solved!Hello,I have a particular situation where we have Two routers one being a 8300 and one a 2911 not able to ping each other their point-to-point Mi...
Hello,I'm trying to get a N520 configured to take over for ME3400 we are replacing. I'm not too familiar at all with Bridge Domain being a replacement for vlans. I'm trying to test a Environment monitor on gig 0/0/0 to be reachable on vlan 16. I'm tr...
Gotcha, so dumb question just call ISP2 and say hey can you make a static pointing to that subnet? Edit: Well they can't point a static since it would direct traffic to a backup port thats not in use....So they just would need to advertise the networ...
