Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a C2500 router, and I am trying to console into it so I can create a study lab here at home. I am using a rollover cable, and a DB9 female to RJ45 adapter. I am connecting that to COM port 1 and using hyper-term. I am using 9600-8-1-N settings...
I was curious to see if anyone has ever heard of this error message, TAP Terminate. It is an ASCII text message that is being generated on several of our RF Scanning Guns. The guns are connected to the network via RF AP using IEEE802.11 technology. S...
I currently have a router that is an LP state. I am not showing the serial interface being in loopback (loopback not set) when I do a show interface cmd. Is there something I need to do to clear it out of an LP state? Jeff
I am putting together a network for a remote site to WAN into our main site at our corporation. I have a Inter-tel Axxess Phone system which has a IPC card for VOIP. I have both routers fully configured. The way the phone works is it uses a static IP...
I am at the point of begging for ideas to try on the issue that I am faced with right now. The situation that I have is I am trying to name resolve from a remote WAN to our main network via C2611 router. The router is fully configured, routes are pro...
thanks everyone for their suggestions, but the problem has been solved. It was in the adapter I was using and apparently the pinouts weren't to cisco standards. I ordered a cisco equivalent adapter part # 74-0495-01 Equivalent RJ45/DB9F RS-232. Do ...
I swapped pins 2 and 3 in the adapter and used a regular straight through patch cable, and still was not able to console in. I have ordered a standard Cisco terminal DB-9F to RJ45. I have seen these work in other labs so hopefully that will resolve ...
Yes, the clients have static IP address, and I have the WINS server IP programmed, and that doesn't seem to do anything. All this time I can see the Dorothy domain, and I can see myself in the dorothy domain, but I can't browse the network or see any...
Update on what I have done if anyone else has any ideas.I successfully added the LMHOSTS pointing to the WINS server. I went to a cmd line, winnt, ran nbtstat -R, and then ran nbtstat -c and I could see the information that I added. I then did a rebo...
