Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
- Cisco Community
- :
- About inb
Stats
Member since
10-18-2017
27
Posts
15
Helpful
0
Solutions
01-28-2021
Thank you for answer.The hello/hold timer value is a result that has
been verified to have a minimum...
01-28-2021
Thank you for answer.We can't switch to hsrp v2.Only when the exact
cause is identified can proceed....
01-26-2021
Thank you for answer.show standby brief-> Active/Standby is changed from
L3 #1,2.Normally, L3 #1 has...
01-26-2021
Top-C3560X-48P-E 2 units:L3 mode, PVST, Downlink port Trunk, HSRP(vlan
10, 20, 30 ...)OS version-15....
01-13-2021
What's your opinion on tesk 2?I think tesk 2 is cleaner.But there is no
way to verify it.
01-13-2021
After reloading at number 14Is the active engine slot 5?Or is slot 6
active before reloading?
01-13-2021
The sup model is 7-e.So I can't use that version.I am going to proceed
with the minimum ROMMON versi...
01-13-2021
Thank you.If so, will procedures 8~13 disappear?Simply through
redundancy force-switchoverIs the pro...
01-13-2021
Good morning.I am trying to upgrade the C4500 engine redundant equipment
to the OS. Current version:...
12-15-2020
Thank you for answer.Does it have anything to do with the reload
command?Currently operating in inst...
12-15-2020
Thank you for answer.When step 6 is finished, both sw 1 and 2 operate in
the same os.If you connect ...
12-15-2020
Hello.I am running a stack of 2 C9300s.The OS is using 16.12.14, which
will be a problem when upgrad...
Public Statistics
| Date Registered | 10-18-2017 05:19 PM |
| Date Last Visited | 02-21-2021 04:08 PM |
| Total Messages Posted | 27 |
| Total Helpful Votes Received | 15 |
