Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have just tried to implement by first 1841 router.I used the same template that I have for over 400 sites ( 1600 , 1700 , 2500 and 3600 series routers ) I get the dlsw peers established no problem.The problem is on the serial interface in the route...
have recently turned on SNMP on my two host rtrs. ( clients ) I have given the CAUnicentre people the host file's which are nat'd IP's on the routers loopback IP address. I have checked the CAUnicentre logs and see the "real" Ip address in the logs....
I have recently turned on SNMP on my two host rtrs. ( clients )I have given the CAUnicentre people the host file's which are nat'd IP's on the routers loopback IP address. I have checked the CAUnicentre logs and see the "real" Ip address in the logs....
Recently we started using IP helper to get the DHCP from a centralized DHCP. I guess it is causing an issue with Windows 2k machines. The lan group is advising me that it is broadcasing PORT 137 and PORT 138. I guess every 13 minutes they try to ...
tks MatthiasI thought first about doing that but figured I should just ask the question first.I will post whatever they tell me cause I have been going crazy looking over my config.
I have done this on a PIX 515 with IOS 6.1(4).I had a lower version orginally and had to upgrade due to the broadcast on port 0.But tradionally DLSW+ uses port 2065.I also had issues with NAt'd - the way I understand that DLSW works with CISCO is tha...
I had looked there prior to doing so and thought I had everything.This is what I have in the firewall.I have 3 interfaces in this f/wall .1 is inside the other two are separate clients and I have named the interface to make life simple.alias (inside)...
