DlSW/SDLC 1841 ROUTER.

[bellefontainea]

I have just tried to implement by first 1841 router.

I used the same template that I have for over 400 sites ( 1600 , 1700 , 2500 and 3600 series routers )

I get the dlsw peers established no problem.

The problem is on the serial interface in the router.

It is an IBM 5494 controller .

Here is the configuration that I have for the serial interface.

I have added the routers configuration.

Any ideas??? Is there something that I need to add to the serial interface on the 1841's that was not required before ???

My IOS is (C1841-ENTBASE-M), Version 12.3(11)T2

tks.

[mbinzer]

Hi,

please open a case with the tac. There have been a few problems with sdlc and 12.3T, also there are some issues depending on the hardware you are using.

The Tac will help you to collect all the needed information to understand your problem and then guide you to a resolution.

thanks...

Matthias

[bellefontainea]

tks Matthias

I thought first about doing that but figured I should just ask the question first.

I will post whatever they tell me cause I have been going crazy looking over my config.