Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need three PC's to connect to a device that has a MM fiber output. The output will be connected to another router at the central office. What would be the best equipment to use.
Is it possible to force a script to be ran on a machine after they connect to the AS5300 or any other Access Server?We have a script that will scan a machine to see if NAV and the most current updates are loaded. We can push is to our LAN users at st...
We have set up the web based password change for our VPN users. The users experience 100% success rate when they follow the 8-14 alphanumeric password restrictions that we set. They also have 100% success rate when they use special characters with th...
It is already supported. Download the linux client from the Cisco Software Center. You have to load and compile the client from the command line of linux and not the GUI.
You will get smaller broadcast domains, but with the equipment you already have, you can run VLANS. If you are looking at 2-4 VLANS the adminstration is realitively low. Once they are set up and you have the ports configured for the appropriate VLANS...
You can use the below document for reference if you need.http://www.cisco.com/en/US/products/hw/wireless/ps430/products_configuration_guide_chapter09186a00800e02cb.html
You can create a management interface on the 1200. VLAN 1 should already be created on the AP. As far as the VLANS and trunks go, all you have to do is trunk the Ethernet link between the 1200 and the switch. If you have 3 VLANS, you will have to set...
