Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,
Do I need to purchase multiple C9800-CL-K9 SKU's if I need to deploy the controller across multiple sites?
For example:
I have 20 access points that I need to deploy across two independent sites for the same customer. I need the sites to...
Hi Guys,May you kindly assist me in troubleshooting the control connection between my vEdge and vBond. It seems they are failing to verify each other's certificates.I am using vManage signed certificates for my WAN edge devices and I have loaded the ...
I need assistance in getting URL redirection for client provisioning to work when my PC is connected behind an IP-Phone.Redirection is working fine when the PC is connected directly to the switch but somehow, redirection is not even attempted when th...
Hi guys,I need help with redirection for ISE posturing.When I manually paste the redirection URL to my browser everything works fine but somehow, I can't get automatic redirection to work.I have attached everything that I think may be helpful for you...
Hi All, I need assistance on SD WAN support on DNA Center.I have read in many DNA licensing documents that it is possible to manage an SD WAN solution on DNA Center but I am yet to come across a document or video on how that is achieved or deployed.M...
H Elesani,Thanks for your response. I managed to figure it out.For some reason, the vEdge was failing to verify the vBond certificate although they were both signed by the same Enterprise root CA. To ensure they were using the exact same root-cert-ch...
Hi Missly2000,I managed to figure out and resolve my problem.My challenge was that I was using Manual (Enterprise CA) for WAN edge certificate authorization so the WAN edge devices would successfully authenticate with vBond using the token but vManag...
Hi Missly2000,I am facing the exact same challenge except that I am using vEdge-Cloud routers for my WAN edge.My debug shows the exact same error.I will update this when I make a breakthroughRegards,Jay
Hi Cristian, Thanks again for your response. You seem to have mistakenly missed those three commands.If you check again, you can see that I in fact do have those commands at port level.I have gone through the prescriptive deployment a couple of times...
