Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a 4 story Hospital building. We originally installed b/g radios in 1200's and later 1130's. We are running WDS, WLSE, and we are using dedicated ap1200's to be WDS manager and Radius server (about 30 WDS clients per manager)The A-Radio client...
We recently moved to redundant sup720-3b's and we kept our Flex WAN WS6182-2pa in service. We are trying to support lat over a serial interface. in the old IOS we used Bridge-group on the serial interface, in the new IOS 12.2(18)SXF4 it isn't availab...
After upgrading ap1200b point to AP1200-Cisco-IOS-Upgrade-Image-v3.img then to c1200-k9w7-tar.122-15.XR2.tar I set 2 vlans with static wep. The virtual dot11radio0 interface is down and an error occured during reset. I have rebooted, and the same. Wh...
I have a static IP for the AP350 point running ios. When I turn off WEP (no EAP or MIC but 128 bit encryption manditory) I could get my IP address. When I reactivate the WEP (static key) I will not get an address. I have checked both the client and t...
I have Common services 2.2 with RME 3.5 and CM 3.3.I would like to install Device Fault Manager from the CD I got with my last upgrade. It asks me for a previous version which I don't have. Contacting my Rep for Cisco they said it was contained in th...
Hi, Winston did not do a survey. We are running the Cisco a-b-g cardbus on some Intel on some, and Altheros abg cards. We configured the WDS Point to authenticate only the points, not clients. We tried even with the Cisco client cards, they seem to h...
I have a T1 connection on one of the Flex WAN ports and using bridge-domain asks for trunking protocol choices. I am doing vlan-bridging to transport some LAT we are still using and up until we upgraded our Sups and IOS we were using Bridge-goup on t...
I have tried the proceedure and after the 3 messages of "Fatal" and the prompt I entered the :resetall command. There is no response other than a representation of the "(Auto Apply On) :BOttom, :Down, ^R, =, , or [Link Text]:" Is there any other pro...
