Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Unity 4.04, Exchange 2003. Two integrations, Call Manager and serial to Intecom switch.For a site that is on CM, the MWI calls are routed to the Intecom legacy switch which then errors since the Intecom does not know about the CM extensions.The switc...
Unity 4.04sr1, Exchange 2k/2003. Single routing group.We are migrating from e2000 to e2003. I have not located any specific steps to move the voice connector for use with Unity Bridge from one exchange server to another. Any help is appreciated.Saba...
UM4.04sr1, Ex2003 off box.Is it possible to use the Bulk Import tool to modify existing subscribers' extension and integration? I have a bunch of subscribers using Intecom integration and they are being migrated to the CallManager with a different e...
UM 4.04sr1, w2k, Exchange 2003.This morning found Unity not answering calls. The only error I found is:Event Type: ErrorEvent Source: CiscoUnity_ConvAddrSearchEvent Category: Error Event ID: 109Date: 8/31/2006Time: 7:21:08 AMDescription:Unexpected...
UM 404sr1, Intecom serial integration, Dialogic 240 PCI-T1 card. Introducing PIMG to replace the Dialogic cards.Can I run the current integration while I add the PIMG integration back to the Intecom pbx? The idea is to run both in parallel and tes...
The integration is the correct one, CallManager. When I looked at the NotifyMWI table, initially, the integration on this table did not match the subscribe table, which is the data that shows up in the subscriber profile page. I made the change in ...
Unity 4.04sr1, Exchange 2003.We are running E2003 on physical servers with SAN data storage. No issues related to Unity specifically. Something to look out for is I/O bottlenecks on the SAN side. There are many ways to configure the SAN luns. We ...
I did not use a timer, just did a count, so it is possible it is 20 seconds. However, the bug imply inside calls within the pbx. No problems there, Unity answers as expected. Calls originating outside the pbx(other offices or public network), to Un...
Ok, got it working pretty decent using smdi to the pimg. Found out the problem was with the serial cable. However, now when we call Unity from a different switch (no caller ID) it rings once and 15 seconds later Unity answers. If Unity knows the nu...
