Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have problems with a WLC 8510 in which on the front I get a message on the screen of 6: D, currently I have it operating in HA but not working properly and I think it could be by this error. You have any idea according to your experience of that me...
Hi everybody,I have an implementation where it was necessary to change the WLC port, for example:IP WLC: 10.10.10.10:8080 (Any port other than sea 80 and 443)This is in order to be able to use other ports and not work with traditional ones, but appar...
Hello,I hope you are well, I currently have a WLC 5520 with firmware 8.5.135 which is recommended by Cisco, use this version because I have APs AIR-AP1832I-N-K9 (It is compatible with this version according to the documentation) and AIR -AP1542I-N-K9...
Que tal a todos buenas tardes,
Tomando en cuenta que la creación de WLAN es una función que nos proporciona la WLC , ahora bien, ¿Cual sería la cantidad de WLAN recomendada que pueda soportar una WLC?
La cuestión se debe a que en un documento que ...
Que tal buenas días,
Tengo un escenario para realizar un Site Survey en 3 áreas de 4x4 aproximadamente, ahora bien, como mejores prácticas,
¿Cual sería la potencia recomendada que debería utilizar el AP Autónomo, entre las posibles potencias que no...
Hi Haydn,Thanks for your comments, then we come to the conclusion that it is not possible to assign a specific port to the WLC other than those that are by default 80 and 443. Thanks for the support. Greetings Cordial
Hi Sathiyanarayanan Ravindran, Thanks for your answer, the reason to change the port is to achieve the remote access but with the condition of handling it as follows, for example: HTTPS or http://10.10.10.10:8080This because in the Firewall I can ass...
Que tal buenas tardes Mauricio,
En el Dashboard de Meraki podemos bloquear clientes o usuarios, ahora bien, ¿Es posible que en el Dashboard de Meraki podamos eliminar a un cliente de forma definitiva?
Quedó en espera de tus comentarios.
Gra...
Thank you Flavio for your comments.
Now, I can not assign the group interface to the wlan, entering the command:
(Cisco Controller) config>wlan interface 1(WLAN id) test (Interface Group)
The ap is restarted, but the wlan 1 is not assigned to t...
Gracias Daniel,
Ahora bien, ya tengo creado mi Interface Group y asignarlo a la WLAN, pero no se esta asociando a la WLAN, te comparto lo que se a realizado hasta el momento.
- Se crean las Vlan:
(Cisco Controller) config>interface create Intv100...
