Hi,Is any one using a cat6k switch for both voice and fax (T.38) gateway in their IPT deployment. I am interested in knowing the following:a: which protocol/s is used btw the CCM and Cat6kb: was CM employed as a fax relay at allc: did you use a diffe...

Hello,Just wanted to know whether there is a any such web based material for training users online especially from Cisco.Thanks.George.

I just upgraded CM 3.2.2c with spF patch and thus managed to wipe my entire ringer list except for two. Any work arounds to resolved this without downgrading?

When the IP addresses on the phones are released and reset. The phone fails to come back up. 'IP address Released' is the message on LCD until the phone is power cycled manuallyIs this some kind of bug??

Hi,Just want to know if the callerID is enabled at the telco end and works on a standard phone will the same work over a fxo port?port configs!voice-port 1/0/0 cptone GB connection plar 01908601000IDEAS PLEASE. ring number 3