Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Can anybody give me any ideas about the following error messages.We have 2 MSFCs with HSRP configured across mulitple vlans, Each has static routes configured and redistributed into OSPF.On one MSFC we get the following error messages about one route...
I have 2 sites linked by 2 2MB circuits each with its own router. I need to implement PBR to move some video conference traffic from the main circuit to the backup circuit.(ID by host ip addresses at each site.)The problem is I need to monitor the ou...
Am I missing something obvious.I'm setting up a VPN Tunnel between a 2621 and a Nortel Contivity 4000 .If the tunnel is initiated from the router it works perfectly.If the tunnel is initiated by the 4000 the router rejects it Debug shows both transf...
One thing to try would be to remove the default ip address from the set ip next-hop statement- I.E change it to set ip next-hop 192.168.1.2Then if the 1.2 link fails PBR should fail and traffic should then follow the default route.NOTEThis will only ...
Looking at it from a simple perspective one option would be to run Enhanced object tracking on the edge routers pinging the DMZ interface on the Pix - should it fail a route map can be used to change the local preference setting the prefered route to...
I've seen similar issues in the past with HSRP.THe best way to test it would be to fail core A, Restore it and then clear the arp cache on both routers, If that doesn't clear the problem clear the MAC table (CAM table if your running CatOS)as well.If...
