I read a post on CPI 2.1 with this same issue; can we run a report showing power line for our switches in CPI 3.4.0? I tried the config template using "do show power inline" but I can't get the cli output although the job runs succesfully. The "canned reports" don't seem to have this and the custom report seems to only use the existing canned reports so I just don't see a way at this point.
Any ideas? Thanks in advance!
... View more
I've searching on CCO to figure out what triggers a re-key event. We need to make some changes to our NTP settings i.e. timezone across our enterprise GETVPN. I'm wondering if changing the clock settings on our routers either GM or KS .
This link on CCO seems to list the known commands that will trigger a re-key:
https://www.cisco.com/en/US/docs/ios-xml/ios/sec_conn_getvpn/configuration/15-2mt/sec-get-vpn.html#GUID-B1DA65AF-C4E5-458E-9AAB-375EFFF564FD
But are these the only ones? Will NTP or changing the clock time spawn a re-keying event?
TIA,
Tom W.
... View more
There's a document floating around somewhere that discusses the client side issue related to tuning I found a link to it on the forums a few months ago. One of the keys for us up to this point was reducing the high average load alarms. We've found this post extremely helpful: https://supportforums.cisco.com/t5/security-blogs/getting-past-intermittent-unexplained-802-1x-problems-on-windows/ba-p/3104109
... View more
We're running 2.2.0.470 patches 1,2,4 We're still working with Cisco Professional services to iron out a lot of client side issue to resolve authentication error messages. Slowness issues in our case were resolved to some degree by patch 2 if I remember correctly, but also by working to resolved some client software issues (turning off NIC sleep among other things) where our logs were being overwhelmed by repeated authentication failure / retries; all this being said we still are in monitor mode and haven't put this into production due to further tuning that's being done.
... View more
