Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I have a user who is unable to logon to Webview.The passwords and permissions have not changed.The user was able to logon earlier and view reports but now it displays an error "you are not authorized to view the page".We tried the URLs http://webview...
There are 2 sites,the central and the remote site,both are 3660 routers.There are 3 T1s going between them.The Third T1 always shows a serial interface up and line protocol down.When the T1 actually goes down,it comes back up only after rebooting the...
we have 32 2600 routers running 11.3(5)T and when we did a Network scanning,29 out of the 32 went into Rommon mode and the remaining 3 of them rebooted themselves and came back up fine.Is there any associated bug for the 2600 with Network scanning.Wh...
HiWe have Unity 3.1-3a and we have this one user who is unable to retrieve the Voice Mail on his PC.All his Viewmail settings are the same as the others.When he plays a Voicemail on his PC,the icon moves just like normal but no audio is heard.The Vol...
We have 2 Routers.The Remote Router(2600) sends the DHCP relay and forwarding packets to the Main Router(4700M).The DHCP forwarding packet has a Gateway IP address of 0.0.0.0.When the packets are relayed with special processing,why do they get forwar...
Yes.I found the SegV Exceptions link and I suspect its bug CSCdm64107.But the routers in ROMMON mode,I am not sure what the issue is yet.The Config register is 0x2102.I will check the bug list again as the routers are running a very early version - 1...
Shanky Only 3 routers rebooted by themselves and came back up.The other routers were manually power-cycled.The reason for last reboot on the 29 routers which went to ROMMON mode is "System restarte by power on" because they were power-cycled.But th...
We are playing the messages on the PC.We can retrieve it on the phone with no problem.This workstation is same as the others in the network.The other audio files are running fine and can be heard fine on the speakers.Only the Unity Voicemail messages...
DonCan a IP DHCP Relay command be applied in this regard instead of the Ip helper address.But I am not sure if we can configure IP addresses with the IP Dhcp Relay Command.Thanks Anu
