Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I guess i am in the correct forum. My cisco 3620 lab computer does not have an IOS that allows me to practive with SDM aleast I could not find the correct IOS. IOS (tm) 3600 Software (C3620-I-M), Version 12.2(29bDRAM configuration is 32 bits wide wit...
My network consist of Cisco 4000 switches and two routers. Both routers are connected to the same switch. One router The router with subnet of 255.255.255.0. is connected to 10meg line and works fine. I have a 800 series router configured for subnet ...
I have one router connected to my core switch and I can ping with no problems. I purchased a second DSL Router but I cannot ping from the core swtich. What configuation changes are needed. The route with the subnet 255.255.255.0 I can connect with no...
I can not boot to a netware 5.1 server using a 3com dos boot disk through a 3500xl switch; however, I can boot through a 4000 catalyst with no problems. The 3500xl switch is connected to a 4000 catalyst switch. Why??? Thanks for any help!!!
What IOS will support HTTP for this router? I have installed on computer but the current IOS does not support Https and IOS I have found are to large. thanks
I do not have access to the routers. I am certain the problem resides with this switch. I can connect the cisco 800 router to cheap dell switch, connect the laptop the the dell switch, and all is well. I can disconnect the patch cable from the dell ...
