Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have client that is connected to my router with BRI. We use "ppp multilink", so both B channels can be used. My client is the caller site and my router is the called one. My client says that all calls are ended in 120seconds although there is st...
Hi,what is the difference using server group instead of using multiple radius-server commands? And ý have one more question: In PIX, when primary ACS goes down secondary ACS take the job. and even primary one comes back secondary ACS is used. Is thi...
Hi,we have an rpc application through the PIX. the client and server are on different segments of the firewall. rpc timeout on PIX is set to 10 minutes. sometimes we have a problem like this: client tries to send a new request to server on its establ...
Hi, I'm using ip auth-proxy feature. And it has a inactivity timeout value that you can confgure on router globally. But I want to set this value on radius per user. I tried to set idle-timeout radius attribute but it didn't affect or override the gl...
Hi,VRF and VRF lite are not comparable concepts. VRF is virtual routing forwarding table. VRF Lite is a way for exchanging VRF routes between two device and expanding the VPN. VRF-lite lets multiple customers share the same physical link between the ...
Route reflectors main purpose is establishing BGP sessions. So if the BGP router-id of the route-reflector is reachable from other MP-BGP PEs (via ospf) , there is no problem..
hi gilles,thank you for quick response.I have one more issue, what if a server sends a FIN or RESET for a connection? Does CSS removes the flow immediately or does it wait for the FIN from the client side, too?
hi Gilles,it's ok that when a flow is marked as idle, it goes to a list and it can be usable again. But when this flow completelty removed and send a RESET? thanks
