Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,we try to build a DMVPN Solution and try to integrate this solution into our MPLS network.Can anybody give me some informations about DMVPN and MPLS VRF configuration.Thanks Peer
Hello,I have build up a DMVPN Solution with a 3725 (12.3-3a) Hun and a Cisco 836 (12.3-7T1) Spoke.The DMVPN Solution is usinf dynamic IP Adresses on the spoke. The configuration is running fine for some days. After some days the tunnel do not work an...
Hello,on of our VPN-Locations has a local network 192.168.0.0 /24 and uses a Cisco router for connection to Internet and a GRE-IPSEC-Tunnel for the connection to an other network. There is a dynamic NAT configured on the router for the internet and f...
Hello,if we try to install our call manager 3.3.3 we get an error message:GetFileVersionInfoSize: Error: 0: The operation completed successfully.We could make the Windows Server installation with the cisco image without any problem. But if we start t...
Hello,is it possible to use virtual templates together with local users? Or can I only use virtual templates tohether with an radius or tacas server?If it is possible to use virtual template wit local users, has anybody a sample config for this kind ...
Hello,if I use a third pool, is it possible to use this NAT in both directions like a static NAT? The pool with only one address will be a dynamic NAT? I'm not shure if I can reach the server from outside like befor with the static NAT.
I have tried to build a virtual-template Config with my Test-Router cisco 1720.But I can not dialin with the virtual template. I try to get a connection from my PC with the User koli. But the call is not accepted. The command "encapsulation ppp" is c...
I have tried to find some informations about Virtual-Profiles and i have read the page "Info on Virtual-Profiles".But I have no idea how to configure virtual profiles for dial in. Can you give me an sample config or a webpage with this info.Thanks
Hello,I have the following config on my PRI Interface:interface Serial1/0:15 ip address 192.168.0.1 255.255.255.0 ip helper-address 172.22.22.1 encapsulation ppp dialer idle-timeout 180 dialer wait-for-carrier-time 60 dialer map ip 192.168.0.11 name ...
Thanks for this information.If I try to enter the line:crypto map rtp local-address Dialer 1the router crash and restarts. I use the software c800-k9osy6-mw.122-13.T.bin I will try some other software.
