Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I running into an issue with Catalyst SD-WAN went trying to push a simple template to a devices. I keep getting the following error no matter what I adjust in the system template:
[7-May-2024 21:50:51 UTC] Configuring device with feature template: c8...
Hi,I working with FTD 6.7 and 7.0 (now called Cisco secure firewall). I noticed that I can do a VTI tunnel to a router, ASA, or other firewall (like Fortinet or PA) that does route based VPNs but when I try and configure a route based VPN tunnel betw...
Dear Community, I'm currently deploying ACI multisite for a client and I have to do it in a phase deployment where we are moving from the old environment to the new local ACI environment. This is not a migration from a existing ACI fabric into Multis...
Hi, Has anyone run into the "Channel down" issue when updating the identity certificate on the Stealthwatch SMCv and SFCv. I'm doing a POC for a client and every time I go an update the identity cert the SMC says "it could save the configuration" and...
Has anyone figured out a way to load balance PSNs behind a F5 load balancer? I looked at some configuration guides and they are all for F5 11.4. I'm using version 13.0 so the direction a not valid from my situation. The main issue I am having is post...
The SD-WAN controller is 20.13.1 and the version of 8K is 17.5.1a. Its a lab environment and it happens when I push a device template to the C8K. I have a vSmart template and it works fine when I pushed it to the two vSmart controllers.
Anurag, Here is a packtet capture from my POC from the PSN to the NAD. I see the source port (coming from the PSN behind the F5) is 30026. Shouldn't that be udp 1700?
Damien, I create a SNAT rule on the F5 (per documentation) so that the PSNs will be translated to the VIP. Are you doing posturing as well at your customers or just authentication?
