Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,When i plug port 1 of a CE500-24LC switch to PC1 it comes up and then connect PC2 to port 2 but while i expect to port 2 goes to wait mode ( amber LED ) and after a minutes comes up, switch acts vice versa i.e. port 1 becomes amber and port 2 beco...
Hi, I have a 7204VXR with PA-MC-8E1/120 module which is handling 12-Mbit/s bandwidth comes from 6 E1 ports and going out via FastEthernet port. Can I replace this box by an old AS5300 which has an 8 ports CE1 card? Thanks,Saeed Zamani.
Hi,I have one layer 3 3750 switch running DHCP for individual VLANs. for some special MAC address i want to assign special IP in each VLAN. Suppose there are 5 VLANs with 10.10.1.0, 10.10.2.0, 10.10.3.0 , 10.10.4.0 and 10.10.5.0 each with /24 mask. ...
Hi, After rebooting a 7507 with one RSP8 installed , system didn't come up and no console messages are displayed on hyper terminal. Normal LED is green, both Master and Slave LEDs are on. I have only one RSP4 as spare in hand. What can i do to see wh...
Hi,I purchased a MCS-7825I-3.0-IPC1 hardware plus CM4.1-K9-7825 software but when try to install the call manager it says that that hardware is not compatible with the software. What is the problem as both part numbers are for 7825 and how can i solv...
Dear HOA PHAM VAN ,I also have same problem as you. Would you please let me know how can i receive 2000.4.1 OS Image? can i get it from you? Please help me.Thanks,Saeed.
actually, my customer wanted Cisco 7507 with 2x DC power supply and 2xRSP8 and i ordered CISCO7507/8X2-MX for that. Is that correct? What type of power dc or ac includes in that part number? and do you mean that PWR-7507/4*2 and PWR/7-DC are same in ...
Thank you for your help and excuse me for late replay. I did whatever you suggest me but get following error message when booting with new catos:rommon 4 >boot cat4000-k9[1].7-4-1.bin26:03.852677: Loading file 10.1.1.1:cat4000-k9[1].7-4-1.bin26:09.10...
under serial port i have this:interface Serial5/1 ip unnumbered FastEthernet0/0 no keepalive no fair-queue ignore dcd dsr serial restart-delay 0i know that problem with WIC-1T is that i can not enter the command "ignore dcs dsr". it only accepts "ign...
