Hi,When i plug port 1 of a CE500-24LC switch to PC1 it comes up and then connect PC2 to port 2 but while i expect to port 2 goes to wait mode ( amber LED ) and after a minutes comes up, switch acts vice versa i.e. port 1 becomes amber and port 2 beco...

Hi, I have a 7204VXR with PA-MC-8E1/120 module which is handling 12-Mbit/s bandwidth comes from 6 E1 ports and going out via FastEthernet port. Can I replace this box by an old AS5300 which has an 8 ports CE1 card? Thanks,Saeed Zamani.

Hi,I have one layer 3 3750 switch running DHCP for individual VLANs. for some special MAC address i want to assign special IP in each VLAN. Suppose there are 5 VLANs with 10.10.1.0, 10.10.2.0, 10.10.3.0 , 10.10.4.0 and 10.10.5.0 each with /24 mask. ...

Hi, After rebooting a 7507 with one RSP8 installed , system didn't come up and no console messages are displayed on hyper terminal. Normal LED is green, both Master and Slave LEDs are on. I have only one RSP4 as spare in hand. What can i do to see wh...

Hi,I purchased a MCS-7825I-3.0-IPC1 hardware plus CM4.1-K9-7825 software but when try to install the call manager it says that that hardware is not compatible with the software. What is the problem as both part numbers are for 7825 and how can i solv...