Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
All, We recently purchased a Cisco 9407 switch with two supervisor modules and four Ethernet line cards. I am currently configuring the switch in our test site. The switch will then be taken to the production site. My question is since I configure al...
Hi all, We have a Cisco 6506 chassis with single supervisor. We have purchased a new supervisor so that we have dual SUP modules at the end of the day. I have looked up online and cannot find the right document for inserting the additional module and...
Hi all, We have two Cisco CAT 6506 switches at our data center site. Each switch only has one Supervisor module (VS-SUP2T-10G). We have purchased an additional SUP module to install into each switch so that we can create a quad SUP VSS. Before we b...
Hi All, I currently would like to export all my object groups and access-lists to excel. In the access list I would like to get the access list name and interface as well. I do not want to copy/paste since it is difficult for a person who do not know...
Hi all, We have two Cisco 6509 switches with single SUP-2T module in each. As per show version, it shows that we are running S2T54-advipservicesk9-mz.spa. We are looking to purchase two additional SUP modules to create quad-VSS between both the swit...
Thanks Reza. I have gone through some documentation online and put some steps together. Can you please review and let me know if this is accurate? I would appreciate all the help since I am doing this for the first time. Establish a console session t...
I do not have a spare chassis. The only alternative is to put that new module to my existing switch. Is there any procedures or link to follow once that module is inserted to my existing chassis?
Reza, Thanks for your note. Unfortunately we have already received the new SUP module and it is different than what I have in the existing switches. Can you please let me know how to proceed?
I dont have a spare chassis. I guess the only other option is to plug to a switch in use. Once I do that, how do I upgrade the firmware on that SUP module?
