Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We upgraded our controler to ver 5 to cure an issue where the 1250 APs would not turn their radios on. The upgrade seemed to cure that issue but it looks to have come back. Has anyone seen this situation before. I am going to look at this in our lab ...
I have a LWAPP tunnel running through a PIX to PIX VPN tunnel. Max frame sizes trying to get accross the LWAPP tunnel get dropped. How I force the PIXs to fragment?
Has anyone had any serious problems using c3560-ipbasek9-mz.122-25.SEE2.bin ?This version has been around for three months or so and appears ok in our lab test environment.
3500XL management hangs. The management interface VLAN shows as up and spanning tree checks out ok, but the affected switches can't ping anything - even a directly connected laptop (plugged into one of the fast ethernet ports configured to access the...
I have a customer that is trying to use the Broadcom Netxtreme Gigabit Ethernet NIC connected to various Cisco switches (2950T, 3550 24 etc) running at 100MBit/sec. When both the NIC and the switch are set to 100FD the link works for upto 2 days but ...
I believe they were on 4.1.x and needed to upgrade to get around another issue. I have other WISMs on later versions of 4.2 and they are ok. This sites manager decided to upgrade to 5.0.X.
If you are trying to re-deploy the controler in another situstion then it may be better to restore the controler to factory defaults.This can be done from the GUI, CLI or from login after power cycling the controler.
Thanks for the reply. The switches are on an earlier version of code, supposedly not affected by that bug, however I am going to suggest an upgrade as there are fixes for quite a few bugs in the later code.
