My two locations are connected to each other over a Bellsouth/ATT MetroE link which is just basically a point to point ethernet connection. Each location has a 6509 running OSPF. Every few seconds I keep getting messages in the 6509 logs, on one end,...

I have a 6509 with redundant SUP 720s. One is active the other is hot standby. How can I upgrade the IOS code without any down time?

Does anyone know if I can use Ciscoworks to get utilization statistics on IMA ports in my 3640?

Can someone tell me why when I enter the "show proc cpu" command at times it comes back and reads 0%

Can someone tell me why when I enter the "show proc cpu" command at times it comes back and reads 0%