Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi there, I am trying achieve some form of redundancy using existing 3750 & a 2960 switches. these are active switches but are not currently setup for redundancy. find attach diagram is my idea of achieving some redundancy however i am not sure if th...
Hi there, I have MPLS running over our terrestrial microwave link to a remote site. our microwave link is operating at MTU 9000 and L2 Switches in the path all have jumbo frame enabled. we now need to setup a backup link via another ISP however the i...
Hi there, I hope i am posting in the correct place. I need assistance with an issue which seems to be related to Multicast. I have a few Cisco 3064 connected in a ring and I wish to pass traffic for a local TV station over this link. i noticed that t...
Hi all, i need assistance with my aaa radius configuration. below is my configuration and as per tcmpdump on the accouting server 172.31.34.33, i am not seeing any dhcp accounting packets coming through. my aim is to forward dhcp packets to the accou...
Hi there, i have a Cisco ASR-920-4SZ-A acting as a Bras on which end users connect. the router acts as a DHCP server. we are installing a bandwidth shaper into our network and this bandwidth shaper will be located within our core network while the Br...
Thank you again @Kasun Bandara . I will take your advise and setup the switches in Star topology. by the way, would you have any links to refer to for setting up the switches in a star topology? here is one i am looking at currently https://www.cisco...
Thank you @Kasun Bandara for your response. Another option I have in mind is to setup the switches in a ring, as per the attach diagram and use port-channel. Would this be possible?
Hi there, further to my previous email, see below the MPLS config on my router on the HQ side and the remote site. these configs below are for when the link is using our primary link which supports 9000bytes MTU value. If we switch to backup link whi...
Thank you for that. so my MPLS router connects via the ISP backup link via Ethernet with MTU 1500. what is the value to set for mpls MTU on my router ethernet interface which connects to the ISP link?
