Hi I have 2 11500's configured with box-to-box redundancy. I have a number of app servers each with dual nic's (which are Teamed) and which are connected directly to the CSS's. Nic 1 in each goes to the master CSS1 and is therefore live. Nic2 goes to...
I have a number of AP1200's installed which were passing a DHCP allocated address to wireless clients using the Primary SSID (open).I now want to manage the AP's from the wired-side only. I have set up a trunk on the 3350 switch using VLAN_MAN as th...
Is there any thing,that limits the maximun Number of acl's on the 7600 router apart from the numbering of the standard, extended acl's and the 31 character limit to named acl's?regards
Thanks Joerg for the info. If you have a pair of content switches in failover mode can you upgrade the standby from 05 to 06 and then failover and upgrade the other, or should take them both offline and upgrade them.regardsj.....
Thanks,d I set up the vlans, one for the app servers and one for the CSS and external users on each switch. I put nic1 from each server into switch 1 and nic2 conected to switch2. I used 2 monitor services to track the state of the the two vlan inter...
Hi Mynul, what i am really trying to do is to allow two hosts (a.a.a.a) and (B.B.B.B) on the outside to access a host (c.c.c.c) on the inside interface using an access list on the outside to restrict which ports have access to ( c.c.c.c). I am ...
I don't want to use nat anywhere, therefore i have a nat (inside) 0 0 0 entry, and the outside hosts are using 8080 via the acl on the outside to access the inside host. There were some pings from the inside host to the the outside hosts , so i ...